                   .:                     :,                                          
,:::::::: ::`      :::                   :::                                          
,:::::::: ::`      :::                   :::                                          
.,,:::,,, ::`.:,   ... .. .:,     .:. ..`... ..`   ..   .:,    .. ::  .::,     .:,`   
   ,::    :::::::  ::, :::::::  `:::::::.,:: :::  ::: .::::::  ::::: ::::::  .::::::  
   ,::    :::::::: ::, :::::::: ::::::::.,:: :::  ::: :::,:::, ::::: ::::::, :::::::: 
   ,::    :::  ::: ::, :::  :::`::.  :::.,::  ::,`::`:::   ::: :::  `::,`   :::   ::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  :::::: ::::::::: ::`   :::::: ::::::::: 
   ,::    ::.  ::: ::, ::`  :::.::    ::.,::  .::::: ::::::::: ::`    ::::::::::::::: 
   ,::    ::.  ::: ::, ::`  ::: ::: `:::.,::   ::::  :::`  ,,, ::`  .::  :::.::.  ,,, 
   ,::    ::.  ::: ::, ::`  ::: ::::::::.,::   ::::   :::::::` ::`   ::::::: :::::::. 
   ,::    ::.  ::: ::, ::`  :::  :::::::`,::    ::.    :::::`  ::`   ::::::   :::::.  
                                ::,  ,::                               ``             
                                ::::::::                                              
                                 ::::::                                               
                                  `,,`


https://www.thingiverse.com/thing:2319144
Hexagon Cup or Planter by Milhooz is licensed under the Creative Commons - Attribution license.
http://creativecommons.org/licenses/by/3.0/

# Summary

I needed an Hexagon container and I saw the Hexagon Succulent Planter by Colleeniebikini, she is not allowing remixes but I wanted to share this anyway. I have created a new model in Fusion 360 so the hole at the bottom is plugged. This way it can be used without a dish or as a cup or all purpose container.

# Print Settings

Printer Brand: Prusa
Printer: Prusa Mk2
Rafts: No
Supports: No

Notes: 
I have included 2 models, one with the same size as the original planter and one that is a bit bigger, this is to allow to print this with the same shell thickness even if you want it bigger.
Small is 40 mm wide between two parallel sides at the top
Big is 50 mm 

Each one is available in 2 different shell thickness, if you print with a *layer width of 0.45mm*, you will be able to make the shell in 2 or 3 perimeters depending on the model you choose.